LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2013 >> Edge SEL, 2.0L Eng VIN 9 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 9 (Engine Mechanical - 3.5L) >> In-Vehicle Repair >> Crankshaft Front Seal >> Installation

Crankshaft Front Seal: Installation

WARNING: This page is about a different variant/trim than selected.
  1. NOTE: Apply clean engine oil to the crankshaft front seal bore in the engine front cover.

    Using the Front Crankshaft Seal Installer and Crankshaft Vibration Damper Installer, install a new crankshaft front seal.

    G08976034
  2. Install the crankshaft pulley. For additional information, refer to CRANKSHAFT PULLEY .
scientia non olet · About LEMON Manuals