Solenoid Body Assembly: Removal
WARNING: This page is about a different variant/trim than selected.
NOTE:
The PCM must be updated with a new solenoid body strategy data file and solenoid body identification anytime a new solenoid body is installed. A new solenoid body service tag must be installed over the current solenoid body service tag on top of the transmission case.
- With the vehicle in NEUTRAL, position it on a hoist. Refer to JACKING & LIFTING .
- Remove the main control cover. Refer to MAIN CONTROL COVER .
- Slide the TR sensor electrical connector lock tab over.
-
NOTE: Handle the solenoid body with care or damage to the solenoid body may occur.