LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2013 >> Edge SEL, 2.0L Eng VIN 9 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Rear Drive Axle/Differential) >> Removal And Installation >> Axle Assembly >> Installation

Axle Assembly: Installation

WARNING: This page is about a different variant/trim than selected.
  1. CAUTION: If replacing the axle assembly, the 4x4 control module will need to be reconfigured with the new Active Torque Coupling (ATC) bar code information. If the new bar code information does not match the existing 4x4 control module information, driveline damage or driveability concerns can occur.

    If installing a new RDU  , re-configure the Automatic Torque Coupling (ATC). Refer to AUTOMATIC TORQUE COUPLING (ATC) CONFIGURATION .

  2. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals