LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2013 >> Edge SEL, 2.0L Eng VIN 9 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Rear Drive Axle/Differential) >> In-Vehicle Repair >> Stub Shaft Seal >> Removal

Stub Shaft Seal: Removal

WARNING: This page is about a different variant/trim than selected.
NOTE: This procedure is for vehicles equipped with a stamped steel cover on the Rear Drive Unit (RDU) only. Vehicles with an aluminum cover on the RDU have no seal installing tools at this time.
NOTE: The Rear Drive Unit (RDU) does not have stub shaft pilot bearings. It has stub shaft seals only.
  1. Remove the halfshaft. For additional information, refer to REAR DRIVE HALFSHAFTS .
  2. Using the Torque Converter Fluid Seal Remover and Slide Hammer, remove the stub shaft seal.
Fig 1: Removing Stub Shaft Seal Using Torque Converter Fluid Seal Remover And Slide Hammer
G06065011Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals