AWD Drive Cycle

WARNING: This page is about a different variant/trim than selected.

Carry out the AWD drive cycle after downloading the ATC solenoid bar code information to the PCM.

NOTE: Always drive the vehicle in a safe manner according to driving conditions and obey all traffic laws.

Carry out 3 accelerations from 0-48 km/h (0-30 mph) in a straight line.
- Perform this procedure at low, medium and full accelerator pedal position.
- Verify that there is no perceived front wheel slip.
On dry pavement, drive the vehicle at 8 km/h (5 mph) in a fully locked turn.
- Verify that there is no driveline binding.