LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2013 >> Edge SEL, 2.0L Eng VIN 9 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 12 (Four Wheel Drive (4WD) Systems) >> Diagnosis And Testing >> All Wheel Drive (AWD) Systems >> Inspection and Verification

Inspection and Verification

WARNING: This page is about a different variant/trim than selected.
  1. Verify the customer concern.
  2. Inspect for obvious signs of mechanical or electrical damage.
    VISUAL INSPECTION CHART

    Mechanical Electrical
    • ATC solenoid (part of rear axle)
    • PTU
    • RDU
    • Halfshafts and CV joints
    • Driveshaft and U-joints
    • Fluid leaks
    • Wheel/tire size and brand
    • Matching tire size and brand
    • Tire pressure
    • BJB fuse 70 (10A)
    • AWD relay module
    • Wiring harness
    • Connector(s)
    • Circuitry
  3. Using a scan tool, clear the DTCs and carry out the PCM self-test.
  4. If the DTCs retrieved are related to the concern, go to the DTC CHART . For all other DTCs, refer to MULTIFUNCTION ELECTRONIC MODULES .
  5. If no DTCs related to the concern are retrieved, GO to SYMPTOM CHART .