- The safety belt warning indicator does not operate
|
- Burned-out indicator
- Wiring, terminals or connectors
- Instrument Panel Cluster (IPC)
- Restraints Control Module (RCM)
|
- If the air bag warning indicator is illuminated, REFER to DIAGNOSIS AND TESTING
. If the air bag warning indicator is not illuminated, REFER to Diagnostic and Testing, Instrument Panel Cluster (IPC) DTC Chart in DTC CHARTS
.
|
- The safety belt warning chime does not operate
|
- Wiring, terminals or connectors
- Safety belt switch
- IPC
- RCM
|
- If the air bag warning indicator is illuminated, REFER to DIAGNOSIS AND TESTING
. If the air bag warning indicator is not illuminated, REFER to Diagnostic and Testing, Instrument Panel Cluster (IPC) DTC Chart in DTC CHARTS
.
|
- The safety belt retractor webbing does not extract or exhibits excessive pressure on the occupant during use
|
- Safety belt retractor is in Automatic Locking Retractor (ALR) mode
- Safety belt retractor binding internally
|
|
- The safety belt retractor webbing does not retract or has excessive slack during use
|
- Twisted or incorrectly routed safety belt webbing
- Safety belt retractor binding internally
|
|
|
|
|
- The Belt-Minder® feature is inoperative
|
- Belt-Minder® feature is deactivated
- Wiring, terminals or connectors
|
- REFER to GENERAL PROCEDURES
or the Seating and Safety Restraints section of the Owner's Literature to activate the Belt-Minder® feature. If the Belt-Minder® is activated, REFER to GENERAL PROCEDURES
to diagnose.
|
- The safety belt tongue is rotated on the safety belt webbing
|
- Twisted or incorrectly routed safety belt webbing
|
|
- The safety belt webbing is dirty or soiled
|
- Dirty or soiled safety belt webbing
|
|