LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2013 >> Edge SEL, 2.0L Eng VIN 9 >> Repair and Diagnosis >> External Pages >> Different car >> Section 293 (Exterior Trim & Ornamentation) >> Removal And Installation >> Rocker Panel Moulding

Rocker Panel Moulding

WARNING: This page is about a different car, the 2014 Lincoln MKX and 2014 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: For information on Ford Color Coded Illustrations refer to COLOR-CODING - FORD .
NOTE: RH shown in illustration, LH similar.
Fig 1: Identifying Rocker Panel Moulding Components
G06505870Courtesy of FORD MOTOR CO.
Item Part Number Description
1 W706805-S Rocker panel moulding rear screw (2 required)
2 W706805-S Rocker panel moulding cap front screw (2 required)
3 7810154 RH/7810155 LH Rocker panel moulding cap
4 78101A04 RH/78101A05 LH Rocker panel moulding
  1. Remove the rocker panel moulding front cap.
    • Remove the 2 screws.
    • Remove the front cap.
      Fig 2: Locating Rocker Panel Moulding End Cap Screws
      G06505713Courtesy of FORD MOTOR CO.
  2. NOTE: RH shown in illustration, LH similar.

    Remove the 2 screws from the rocker panel moulding inside the rear wheelhouse.

    Fig 3: Locating Rocker Panel Moulding Screws
    G06505872Courtesy of FORD MOTOR CO.
  3. Open the front and rear doors.
  4. Release the retainers on the bottom of the rocker panel moulding.
    Fig 4: Locating Rocker Panel Moulding Retainers
    G06505873Courtesy of FORD MOTOR CO.
  5. Pull outward to release the rocker panel moulding from the body, starting from the front of the vehicle moving rearward.
  6. To install, reverse the removal procedure.