Removal and Installation
WARNING: This page is about a different car, the 2014 Lincoln MKX and 2014 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the liftgate trim panel. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION .
- Remove the 6 liftgate applique nuts.
- Remove the liftgate applique.
- Disconnect the liftgate applique electrical connector.
- Disconnect the 2 clips (1 at either end of the applique) and remove the liftgate applique.
- To install, reverse the removal procedure.
- Transfer parts as necessary.
-
NOTE: The rear video camera guidelines will not display if the rear video camera is not configured.
If equipped with rear video camera, configure the rear video camera following the instructions on the scan tool.