LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2013 >> Edge SEL, 2.0L Eng VIN 9 >> Repair and Diagnosis >> External Pages >> Different car >> Section 291 (Side And Rear Vision) >> Diagnosis And Testing >> Blind Spot Monitoring >> Principles of Operation >> Notes

Principles of Operation: Notes

WARNING: This page is about a different car, the 2014 Lincoln MKX and 2014 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: When a MyKey™ restricted key is in use, the Blind Spot Information System (BLIS®) and Cross Traffic Alert (CTA) system cannot be turned off in the Instrument Panel Cluster (IPC).
NOTE: If the vehicle is towing a trailer the BLIS®  or CTA  system may detect the trailer and cause a false alert.
NOTE: The BLIS®  and CTA  system both utilize the Side Obstacle Detection Control Module - Left (SOD-L), Side Obstacle Detection Control Module - Right (SOD-R) and the exterior mirror BLIS®  /CTA  LEDs.

The BLIS®  and CTA  system utilizes 2 modules that have integral radar sensors located rearward of the rear wheel under the rear bumper cover. The 2 modules, SOD-L  and SOD-R  , are hardwired to the exterior mirrors to illuminate the LEDs. The SOD-L  and SOD-R  run a self-diagnostic check on each vehicle start cycle and illuminate the exterior mirror BLIS®  /CTA  amber LED for approximately 3 seconds indicating the BLIS®  and CTA  is operational. For BLIS®  , the exterior mirror BLIS®  /CTA  LED is at 95 percent illumination to be seen clearly during the day and is dimmed down to 10 percent at night. For the CTA  system, the exterior mirror BLIS®  /CTA  LED is always at 85 percent illumination.

The SOD-L  and SOD-R  receive and send network messages over the Medium Speed Controller Area Network (MS-CAN) to communicate with the Body Control Module (BCM), Instrument Panel Cluster (IPC) and Parking Aid Module (PAM).