Video Camera: Installation
WARNING: This page is about a different car, the 2014 Lincoln MKX and 2014 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
Edge
- Install the rear video camera and install the rear video camera bracket.
- Connect the electrical connector.
- Tighten the rear video camera bracket screw through the access hole.
- Cut a piece of mylar tape (19E523) 12.7 mm (0.5 in) long and cover the access hole.
- Install a new name plate onto the rear liftgate applique.
- Install the rear liftgate applique. For additional information, refer to EXTERIOR TRIM AND ORNAMENTATION .
-
NOTE: If the camera was replaced, the rear video camera guidelines will not display if the rear video camera is not configured.
Configure the rear video camera following the instructions on the scan tool.
MKX
- Install the rear video camera and install the rear video camera bracket.
- Connect the electrical connector.
- Install the rear video camera bracket screw.
- Install the rear liftgate trim panel. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION .
-
NOTE: If the camera was replaced, the rear video camera guidelines will not display if the rear video camera is not configured.
Configure the rear video camera following the instructions on the scan tool.