LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2013 >> Edge SEL, 2.0L Eng VIN 9 >> Repair and Diagnosis >> External Pages >> Different car >> Section 290 (Parking Aid System) >> Removal And Installation >> Parking Aid Module (PAM) >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2014 Lincoln MKX and 2014 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
  1. NOTE: Module configuration is only required if a new Parking Aid Module (PAM) is being installed.

    Upload the PAM  configuration to the scan tool. For additional information, refer to PROGRAMMABLE MODULE INSTALLATION (PMI) .

  2. Remove the LH rear quarter trim panel. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION .
  3. Remove the 2 nuts and the PAM  .
    • Disconnect the electrical connector.
  4. To install, reverse the removal procedure.
    • Download the configuration information to the PAM  . For additional information, refer to MODULE CONFIGURATION to carry out PMI  .
scientia non olet · About LEMON Manuals