Body Control Module (BCM) DTC Chart
WARNING: This page is about a different car, the 2014 Lincoln MKX and 2014 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
This module utilizes a 5-character DTC followed by a 2-character failure-type code. The failure-type code provides information about specific fault conditions such as opens, or shorts to ground. Continuous memory DTCs have an additional 2-character DTC status code suffix to assist in determining DTC history.
| DTC | Description | Action |
|---|---|---|
| B115E:01 | Camera Module: General Electrical Failure | DTC B115E:01 sets in the BCM when the video camera status indicates corrupted data with in the video camera. CLEAR the DTCs. REPEAT the self-test. If DTC B115E:01 is retrieved again, INSTALL a new video camera. REFER to VIDEO CAMERA . TEST the system for normal operation. |
| B115E:08 | Camera Module: Bus Signal/Message Failure | If the vehicle is equipped with a 8 in (203.2 mm) touchscreen, GO to PINPOINT TEST G . If the vehicle is equipped with a 4.2 in (106.68 mm) touchscreen, GO to PINPOINT TEST J . |
| B115E:49 | Camera Module: Internal Electronic Failure | CLEAR the DTCs. REPEAT the self-test. If DTC B115E:49 is retrieved again, INSTALL a new video camera. REFER to VIDEO CAMERA . TEST the system for normal operation. |
| B115E:55 | Camera Module: Not Configured | DTC B115E:55 sets in the BCM when the video camera is not configured. The video camera needs to be configured through the BCM . CARRY OUT the video camera configuration using the scan tool under Body > RVC configuration. TEST the system for normal operation. |
| All other DTCs | - | REFER to the DIAGNOSTIC TROUBLE CODE (DTC) CHART . |