LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2013 >> Edge SEL, 2.0L Eng VIN 9 >> Repair and Diagnosis >> External Pages >> Different car >> Section 289 (Sunroof - Roof Opening Panel) >> Removal And Installation >> Roof Opening Panel Trim - Fixed Glass, Interior >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2014 Lincoln MKX and 2014 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the sunshade(s) to the fully OPEN position.
  2. Carefully bend/pry the trim ring from its hook-and-loop tape pads.
  3. NOTE: A piece of paper may assist in keeping the hook-and-loop tape from sticking while aligning the trim ring. Once the trim ring is in position (front and rear locating pins lined up), remove the paper and press the trim firmly in place.

    Carefully bend the roof opening panel interior fixed glass trim and working from one corner remove the roof opening panel interior fixed glass trim.

    • To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals