Primary Seal Alignment

WARNING: This page is about a different car, the 2014 Lincoln MKX and 2014 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Primary Seal Alignment Dimension

Courtesy of FORD MOTOR CO.

NOTE: The primary seal seam is placed at the rear centerline.

NOTE: Make sure the primary seal lip is facing outward.

Install the primary seal. Refer to the illustration.
NOTE: When the roof opening sliding glass panel is in the VENT position, the roof opening panel primary seal should contact the leading edge of the sliding glass.

Install the roof opening panel sliding glass. For additional information, refer to ROOF OPENING PANEL GLASS - FRONT SLIDING .
- Initialize the roof opening panel motor(s). For additional information, refer to ROOF OPENING PANEL MOTOR INITIALIZATION .