Removal and Installation

WARNING: This page is about a different car, the 2014 Lincoln MKX and 2014 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.

Remove the headliner. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION .
Disconnect the electrical connectors to the roof opening panel sliding glass motor, shade motor and main harness.
NOTE: Make note of all the cable wrap locations attaching the harness to the drive tubes, they must be reinstalled at the exact same locations.

Remove the cable wraps and the wiring harness.

Fig 1: Locating Cable Wraps And Wiring Harness
Courtesy of FORD MOTOR CO.
NOTE: Be careful not to overtighten cable wraps during assembly to prevent crimping the cable sheath.

To install, reverse the removal procedure.