Removal and Installation

WARNING: This page is about a different car, the 2014 Lincoln MKX and 2014 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.

Open the roof opening panel to the VENT position.
Detach the top of the concertina blind from the moving glass frame.
Reposition the sliding glass panel to any position rearward of VENT position.
Remove the 4 roof opening panel glass front screws.
- To install, tighten to 8 Nm (71 lb-in).
Fig 1: Locating Roof Opening Panel Glass Front Mounting Screws
Courtesy of FORD MOTOR CO.
Remove the 2 roof opening panel glass rear screws.
- To install, tighten to 8 Nm (71 lb-in).
Fig 2: Locating Roof Opening Panel Glass Rear Mounting Screws
Courtesy of FORD MOTOR CO.
NOTE: It is possible for the rail assembly slide to move freely once the glass panel is removed. Do not move the rail assembly slide rearward or it may disengage from the roof rail assembly rear track.

Carefully remove the roof opening panel glass.
To install, reverse the removal procedure.
- Initialize the roof opening panel motor(s). For additional information, refer to ROOF OPENING PANEL MOTOR INITIALIZATION .