LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2013 >> Edge SEL, 2.0L Eng VIN 9 >> Repair and Diagnosis >> External Pages >> Different car >> Section 289 (Sunroof - Roof Opening Panel) >> Removal And Installation >> Rail Assembly Slider >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2014 Lincoln MKX and 2014 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the roof opening panel sliding glass. For additional information, refer to ROOF OPENING PANEL GLASS - FRONT SLIDING .
  2. Carefully slide the rail assembly slide forward and out of the front of the roof rail assembly rear track.
    Fig 1: Sliding Rail Assembly Forward
    G06286099Courtesy of FORD MOTOR CO.
  3. NOTE: Make sure the rail assembly slide guide shoes are installed in the roof rail assembly rear track and aligned correctly during installation. The guide shoes cannot be serviced separately.

    To install, reverse the removal procedure.

scientia non olet · About LEMON Manuals