Roof Opening Panel: Notes

WARNING: This page is about a different car, the 2014 Lincoln MKX and 2014 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.

The roof opening panel consists of the following:

Air deflector
Concertina blinds
Fixed glass front seal
Fixed glass side seals
Front shade assembly
Front trim panel
Front trim panel seal
Motor wiring harness
Overhead console control switch
Rear shade assembly
Roof opening panel fixed glass
Roof opening panel shade motor
Roof opening panel sliding glass
Roof opening panel sliding glass motor
Roof rail assembly front track
Roof rail assembly rear track
Rear trim ring assembly
Shade motor block and drive tube assembly
Shade track and mechanism
Sliding front panel motor block and drive tube assembly
Sliding glass primary seal
Side trim panel
Side trim panel seals
NOTE: The roof opening panel control switch operates both the power shade and the sliding glass panel. Any glass opening operation will first fully open the shade panels. Before the shade panels may be closed, the glass panel must be fully closed.

NOTE: One-touch open/close/vent operation can be cancelled anytime the shade panels or sliding glass is moving by activating the roof opening panel control switch or TILT control switch in either direction.