LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2013 >> Edge SEL, 2.0L Eng VIN 9 >> Repair and Diagnosis >> External Pages >> Different car >> Section 287 (Windows And Glass - Glass, Frames And Mechanisms) >> General Procedures >> Window Motor Initialization >> De-Initialization procedure

De-Initialization procedure

WARNING: This page is about a different car, the 2014 Lincoln MKX and 2014 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: The front window motor must be reset to its original factory settings first, then carry out the following de-initialization procedure.
  1. Turn the ignition key ON.
  2. Operate the window control switch in one-touch mode and remove power from the window motor while the window is moving  by one of the following methods:
    1. Disconnect the vehicle battery cable while the window is moving  .
    2. Disconnect the window motor connector while the window is moving  .
    3. Remove the LH or RH front window motor fuse while the window is moving  .
  3. This will de-initialize the window motor and reset the window motor to its original factory settings.
  4. Carry out the initialization procedure to turn the one-touch-up feature on.
scientia non olet · About LEMON Manuals