A/C Condenser
WARNING: This page is about a different car, the 2014 Lincoln MKX and 2014 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The A/C condenser for this vehicle is produced from the factory with a receiver/drier desiccant bag installed in the integrated receiver/drier. This receiver/drier desiccant bag may become contaminated with moisture if the A/C condenser is not installed for an extended period of time. Since it cannot be determined how much time has elapsed between production and installation of the unit as a service part, remove and replace the receiver/drier desiccant bag with the separate receiver/drier desiccant bag supplied with the A/C condenser service part kit.
The A/C condenser is an aluminum fin-and-tube design heat exchanger located in front of the vehicle radiator. It cools compressed refrigerant gas by allowing air to pass over fins and tubes to extract heat and by condensing gas to liquid refrigerant as it is cooled.
The receiver/drier is incorporated onto the LH side of the A/C condenser. The receiver/drier desiccant bag is a separate component and can be separately removed and installed with the A/C condenser removed from the vehicle.