Removal and Installation
WARNING: This page is about a different car, the 2014 Lincoln MKX and 2014 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the Air Cleaner (ACL) outlet pipe. For additional information, refer to INTAKE AIR DISTRIBUTION AND FILTERING .
- Disconnect the throttle body electrical connector.
- Disconnect the fuel vapor tube retainer.
- Remove the 4 bolts and the Throttle Body (TB).
- Discard the TB gasket.
- To install, tighten to 10 Nm (89 lb-in).
-
NOTE: Install a new TB gasket.
To install, reverse the removal procedure.