LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2013 >> Edge SEL, 2.0L Eng VIN 9 >> Repair and Diagnosis >> External Pages >> Different car >> Section 276 (Engine Controls - Fuel Charging And Controls - 2.0L GTDI) >> Removal And Installation >> Fuel Pump Control Module >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2014 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. Disconnect the Fuel Pump Control Module (FPCM) electrical connector.
  3. NOTE: Do not overtighten the fasteners or damage to the module may occur.

    Remove the 2 FPCM  bolts.

    • To install, tighten to 5 Nm (44 lb-in).
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals