LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2013 >> Edge SEL, 2.0L Eng VIN 9 >> Repair and Diagnosis >> External Pages >> Different car >> Section 271 (Engine Cooling System) >> Removal And Installation >> Thermostat Housing - 3.5L, 3.7L >> Removal

Thermostat Housing - 3.5L, 3.7L: Removal

WARNING: This page is about a different car, the 2014 Lincoln MKX and 2014 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
  1. Drain the cooling system. For additional information, refer to COOLING SYSTEM DRAINING, FILLING AND BLEEDING  .
  2. Remove the Air Cleaner (ACL) outlet pipe. For additional information, refer to INTAKE AIR DISTRIBUTION AND FILTERING .
  3. Release the clamps, disconnect the 5 coolant hoses from the thermostat housing and position them aside.
  4. Remove the 2 thermostat housing bolts.
  5. NOTE: Do not pull the other end of the coolant tube out of the engine block when separating the thermostat housing.

    Separate the thermostat housing from the coolant tube and remove the thermostat housing.

    • Remove and discard the thermostat housing-to-coolant inlet pipe O-ring seal and the thermostat housing gasket.
scientia non olet · About LEMON Manuals