LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2013 >> Edge SEL, 2.0L Eng VIN 9 >> Repair and Diagnosis >> External Pages >> Different car >> Section 271 (Engine Cooling System) >> Removal And Installation >> Radiator - 3.5L, 3.7L >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2014 Lincoln MKX and 2014 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
  1. Drain the cooling system. For additional information, refer to COOLING SYSTEM DRAINING, FILLING AND BLEEDING  .
  2. Remove the cooling fan motor and shroud. For additional information, refer to COOLING FAN MOTOR AND SHROUD - 2.0L GTDI  or COOLING FAN MOTOR AND SHROUD - 3.5L, 3.7L  .
  3. Remove the front bumper cover. For additional information, refer to BUMPERS .
  4. Release the clamp and disconnect the upper radiator hose from the radiator.
  5. Release the clamp and disconnect the degas bottle-to-radiator hose from the radiator.
  6. Release the clamp and disconnect the lower radiator hose from the radiator.
  7. Remove the compressor-to-condenser discharge line bracket bolt.
    • To install, tighten to 7 Nm (62 lb-in).
  8. Remove the 2 upper radiator support bracket bolts and position the radiator toward the engine.
    • To install, tighten to 5 Nm (44 lb-in).
  9. Remove the 2 upper radiator support brackets.
  10. Detach the A/C line pushpins from the radiator.
  11. Remove the 2 A/C condenser bolts from the radiator and separate the condenser from the radiator.
    • To install, tighten to 10 Nm (89 lb-in).
  12. Remove the radiator.
  13. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals