LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2013 >> Edge SEL, 2.0L Eng VIN 9 >> Repair and Diagnosis >> External Pages >> Different car >> Section 269 (Handles, Locks, Latches And Entry Systems) >> Removal And Installation >> Rear Door Latch >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2014 Lincoln MKX and 2014 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the rear door window regulator and motor. For additional information, refer to GLASS, FRAMES AND MECHANISMS .
  2. Disconnect the interior door handle actuating cable.
  3. Disconnect the door handle reinforcement actuating rod.
  4. Release the door latch rear locking clip.
    Fig 1: Locating Door Latch Rear Locking Clip
    G06506060Courtesy of FORD MOTOR CO.
  5. Release the door latch front locking clip.
    1. Disconnect the door latch electrical connector.
    2. Release the door latch front locking clip.
    Fig 2: Identifying Door Latch Electrical Connector And Front Locking Clip
    G06506061Courtesy of FORD MOTOR CO.
  6. Disconnect the door lock actuating rod.
  7. Remove the door latch.
  8. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals