LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2013 >> Edge SEL, 2.0L Eng VIN 9 >> Repair and Diagnosis >> External Pages >> Different car >> Section 269 (Handles, Locks, Latches And Entry Systems) >> Removal And Installation >> Liftgate Release Switch >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2014 Lincoln MKX and 2014 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the liftgate trim panel. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION .
  2. Disconnect the liftgate release switch electrical connector.
  3. Remove the 2 liftgate release switch moulding bolts.
    • To install, tighten to 12 Nm (106 lb-in).
  4. Press the tabs and remove the liftgate release switch.
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals