LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2013 >> Edge SEL, 2.0L Eng VIN 9 >> Repair and Diagnosis >> External Pages >> Different car >> Section 269 (Handles, Locks, Latches And Entry Systems) >> Diagnosis And Testing >> Handles, Locks, Latches and Entry Systems - Without Intelligent Access (IA) >> Inspection and Verification

Inspection and Verification

WARNING: This page is about a different car, the 2014 Lincoln MKX and 2014 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
  1. Verify the customer concern.
  2. Visually inspect for obvious signs of mechanical or electrical damage.
    VISUAL INSPECTION CHART

    Mechanical Electrical
    • Door/liftgate handles
    • Binding latch mechanisms
    • Body Control Module (BCM) fuse(s):
      • 18 (10A)
      • 20 (20A)
      • 25 (15A)
    • Wiring, terminals or connectors
    • Door lock control switches
    • Integrated Keyhead Transmitter (IKT)
    • Keyless entry keypad
    • TPM  module
    • BCM 
  3. If an obvious cause for an observed or reported concern is found, correct the cause (if possible) before proceeding to the next step.
  4. NOTE: Make sure to use the latest scan tool software release.

    If the cause is not visually evident, connect the scan tool to the Data Link Connector (DLC).

  5. NOTE: The Vehicle Communication Module (VCM) LED prove-out confirms power and ground from the DLC are provided to the VCM  .

    If the scan tool does not communicate with the VCM  :

    • check the VCM  connection to the vehicle.
    • check the scan tool connection to the VCM  .
    • refer to MODULE COMMUNICATIONS NETWORK , No Power To The Scan Tool, to diagnose no power to the scan tool.
  6. If the scan tool does not communicate with the vehicle:
    • verify the ignition key is in the ON position.
    • verify the scan tool operation with a known good vehicle.
    • refer to MODULE COMMUNICATIONS NETWORK to diagnose no response from the PCM.
  7. Carry out the network test.
    • If the scan tool responds with no communication for one or more modules, refer to MODULE COMMUNICATIONS NETWORK .
    • If the network test passes, retrieve and record the continuous memory DTCs for the BCM  .
  8. Clear the continuous DTCs and carry out the self-test diagnostics for the BCM  .
  9. If the DTCs retrieved are related to the concern, go to DTC CHARTS . For all other DTCs, refer to the DIAGNOSTIC TROUBLE CODE (DTC) CHART .
  10. If no DTCs related to the concern are retrieved, GO to SYMPTOM CHART - ELECTRICAL  or GO to SYMPTOM CHART - MECHANICAL .
scientia non olet · About LEMON Manuals