Pinpoint Test Ag: An Individual Button/Feature Is Inoperative From The RKE Transmitter

WARNING: This page is about a different car, the 2014 Lincoln MKX and 2014 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: The panic feature only operates when the ignition is in the OFF mode.

AG1 VERIFY THE DOOR LOCK OPERATION
- Press the lock and unlock button on the driver door lock control switch while observing the door lock operation.
Do the door locks operate correctly?
- Yes : GO to AG2.
- No : CHECK the symptom(s) and GO to SYMPTOM CHART - ELECTRICAL .
AG2 VERIFY THE HAZARD LAMP OPERATION
- Place the hazard switch in the ON position.
Do the hazard lamps operate correctly?
- Yes : GO to AG3.
- No : REFER to EXTERIOR LIGHTING .
AG3 VERIFY THE LIFTGATE OPERATION
- Press an interior power liftgate switch.
Does the power liftgate open?
- Yes : GO to AG4.
- No : REFER to BODY CLOSURES .
AG4 VERIFY THE HORN OPERATION
- Enter the following diagnostic mode on the scan tool: BCM DataLogger.
- Select the BCM PID (HORN) and active command the horn on.
Does the horn sound when commanded on?
- Yes : For vehicles equipped with the factory remote start, GO to AG5.
  For vehicles without the factory remote start, REPLACE and PROGRAM the inoperative IA key. REFER to ANTI THEFT - PASSIVE ANTI-THEFT SYSTEM (PATS) . TEST the system for normal operation.
- No : REFER to HORN .
AG5 VERIFY THE REMOTE START BUTTON
- Enter the following diagnostic mode on the scan tool: RFA module DataLogger.
- Select the RFA module PID (Lst_Xm_B_Prs) while pressing the remote start button on an IA key.
Does the PID indicate the remote start button is being pressed?
- Yes : REFER to STARTING SYSTEM to diagnose the remote start system.
- No : REPLACE and PROGRAM the inoperative IA key. REFER to ANTI THEFT - PASSIVE ANTI-THEFT SYSTEM (PATS) . TEST the system for normal operation.