With Intelligent Access (IA)
WARNING: This page is about a different car, the 2014 Lincoln MKX and 2014 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
To enter PATS
security access if the Remote Function Actuator (RFA) module or BCM
is replaced, start a vehicle session using a tear tag or PCM part number. Refer to INSPECTION AND VERIFICATION
to start a session. PATS
security access can still be granted even with the ignition off.
NOTE:
There are 2 parameter reset procedures in the scan tool. Select the appropriate procedure depending upon which module was replaced.
- From the scan tool, enter TOOLBOX. Select Body>Security>PATS Functions and follow the Integrated Diagnostic System (IDS) on-screen instructions to enter PATS security access.
- Select the appropriate parameter reset from the table.
Module Replaced Parameter Reset Procedure RFA module Select parameter reset BCM and RFA module. The customers keys (minimum of 2) must also be programmed to the new RFA module. Refer to KEY PROGRAMMING USING DIAGNOSTIC EQUIPMENT . PCM With the ignition in the ON mode, select parameter reset BCM and PCM BCM Select parameter reset BCM and RFA module. Cycle the ignition to the ON mode and enter PATS security access again. Select parameter reset BCM and PCM.