LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2013 >> Edge SEL, 2.0L Eng VIN 9 >> Repair and Diagnosis >> External Pages >> Different car >> Section 264 (Anti-Theft System - Passive Anti-Theft System (Pats)) >> Diagnosis And Testing >> Anti-Theft - With Intelligent Access (IA) >> Principles of Operation >> Push Button Start Components >> No Key Detected Message

No Key Detected Message

WARNING: This page is about a different car, the 2014 Lincoln MKX and 2014 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.

The NO KEY DETECTED message can be displayed in the message center in either of the following scenarios.

When the ignition is off and the start/stop switch is pressed and a programmed IA  key is not detected inside the vehicle.

When the engine has been started or the ignition is in the RUN mode and an IA  key is no longer detected inside the vehicle. The RFA  module activates all passive start antennas to search the inside of the vehicle for an IA  key any time a door or liftgate is opened and then closed or the vehicle is in motion. This strategy prevents the IA  key from being separated from an already running vehicle. If an IA  key is no longer in the vehicle, the ignition remains in RUN and the engine continues to run. If the start/stop switch is pressed to turn the ignition off, the engine can be restarted without an IA  key present inside the vehicle for approximately 20 seconds, during that time RESTART NOW OR KEY IS NEEDED is displayed in the message center. After 20 seconds an IA  key has to be present to start the engine or transition the ignition out of off.