Removal and Installation
WARNING: This page is about a different car, the 2014 Lincoln MKX and 2014 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the driver air bag module. For additional information, refer to SUPPLEMENTAL RESTRAINT SYSTEM .
-
NOTE: Mark the steering wheel and column shaft for reference during installation.
Remove and discard the steering wheel bolt.
- To install, tighten the new bolt to 48 Nm (35 lb-ft).
- Disconnect the steering wheel switches electrical connector.
-
NOTE: Do not remove the steering wheel by hitting the shaft with a hammer. Damage to the column may occur.
Using a suitable puller, remove the steering wheel.
- Tape the clockspring center rotor to the outer housing to keep it from rotating.
- To install, reverse the removal procedure.
- Align the steering wheel using the reference mark.