LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2013 >> Edge SEL, 2.0L Eng VIN 9 >> Repair and Diagnosis >> External Pages >> Different car >> Section 263 (Steering Column) >> Removal And Installation >> Steering Column Motor - Tilt >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2014 Lincoln MKX and 2014 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the steering column shrouds. For additional information, refer to STEERING COLUMN SHROUD .
  2. Remove the 2 screws, detach the in-vehicle temperature sensor and hose assembly (if equipped) and remove the steering column opening trim panel.
    • To install, tighten to 5 Nm (44 lb-in).
  3. Disconnect the steering column tilt motor electrical connector.
  4. Remove the 2 steering column tilt motor screws and the steering column tilt motor.
    • To install, tighten to 4 Nm (35 lb-in).
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals