LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2013 >> Edge SEL, 2.0L Eng VIN 9 >> Repair and Diagnosis >> External Pages >> Different car >> Section 263 (Steering Column) >> Diagnosis And Testing >> Steering Column >> DTC Chart

DTC Chart

WARNING: This page is about a different car, the 2014 Lincoln MKX and 2014 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Refer to DESCRIPTION AND OPERATION , Intelligent Access with Push Button Start to review the procedures for achieving the various ignition states on vehicles with this feature.
STEERING COLUMN CONTROL MODULE DTC DESCRIPTION

DTC Description Action
B1298:09 Steering Column Adjust Up Switch: Component Failure INSTALL a new steering column control switch. REFER to STEERING COLUMN SWITCHES .
CLEAR the DTCs. VERIFY correct system operation. REPEAT the self-test.
If DTC B1298:09 returns, INSTALL a new Steering Column Control Module (SCCM). REFER to STEERING COLUMN SWITCHES .
CLEAR the DTCs. VERIFY correct system operation. REPEAT the self-test.
B1299:09 Steering Column Adjust Down Switch: Component Failure INSTALL a new steering column control switch. REFER to STEERING COLUMN SWITCHES .
CLEAR the DTCs. VERIFY correct system operation. REPEAT the self-test.
If DTC B1299:09 returns, INSTALL a new Steering Column Control Module (SCCM). REFER to STEERING COLUMN SWITCHES .
CLEAR the DTCs. VERIFY correct system operation. REPEAT the self-test.
B12A1:09 Steering Column Adjust Out Switch: Component Failure INSTALL a new steering column control switch. REFER to STEERING COLUMN SWITCHES .
CLEAR the DTCs. VERIFY correct system operation. REPEAT the self-test.
If DTC B12A1:09 returns, INSTALL a new Steering Column Control Module (SCCM). REFER to STEERING COLUMN SWITCHES .
CLEAR the DTCs. VERIFY correct system operation. REPEAT the self-test.
B12A2:09 Steering Column Adjust In Switch: Component Failure INSTALL a new steering column control switch. REFER to STEERING COLUMN SWITCHES .
CLEAR the DTCs. VERIFY correct system operation. REPEAT the self-test.
If DTC B12A2:09 returns, INSTALL a new Steering Column Control Module (SCCM). REFER to STEERING COLUMN SWITCHES .
CLEAR the DTCs. VERIFY correct system operation. REPEAT the self-test.
B1375:18 Steering Column Tilt Motor: Circuit Current Below Threshold GO to PINPOINT TEST A .
B1375:19 Steering Column Tilt Motor: Circuit Current Above Threshold GO to PINPOINT TEST A .
B1375:71 Steering Column Tilt Motor: Actuator Stuck GO to PINPOINT TEST A .
B137E:18 Steering Column Telescope Motor: Current Below Threshold GO to PINPOINT TEST A .
B137E:19 Steering Column Telescope Motor: Current Above Threshold GO to PINPOINT TEST A .
B137E:71 Steering Column Telescope Motor: Actuator Stuck GO to PINPOINT TEST A .
B1C33:11 Steering Column Tilt Feedback Signal: Circuit Short To Ground GO to PINPOINT TEST C .
B1C33:12 Steering Column Tilt Feedback Signal: Circuit Short To Battery GO to PINPOINT TEST C .
B1C35:11 Steering Column Telescope Feedback Signal: Circuit Short To Ground GO to PINPOINT TEST C .
B1C35:12 Steering Column Telescope Feedback Signal: Circuit Short To Battery GO to PINPOINT TEST C .
- All Other SCCM  DTCs REFER to STEERING COLUMN SWITCHES .