Seat Track: Installation

Passenger seat with fold-flat backrest 

1. Make sure the fold-flat recliner cable is routed correctly between the power seat track cross tube and cushion frame.
   Fig 1: Locating Fold-Flat Recliner Cable

   Courtesy of FORD MOTOR CO.

   All seats 

2. Install the 4 seat track-to-cushion frame bolts.
   • Tighten to 23 Nm (17 lb-ft).

   All passenger seats 

3. For correct front passenger seat cushion wire harness routing, refer to SEAT WIRE HARNESS ROUTING - FRONT PASSENGER CUSHION .
4. Connect the OCS  weight sensor bolt electrical connectors and attach any retainers holding the wire harness to the seat track.
5. Connect the OCSM  and attach any wire harness retainers to the seat track.

   Passenger seat with power seat track 

6. If equipped, connect the DCSM  electrical connectors and attach any retainers holding the wire harness to the seat track.

   Driver seat 

7. If equipped, connect the DSM  electrical connectors and attach any retainers holding the wire harness to the seat track.
8. Connect the seat track position sensor and attach any retainers holding the wire harness or electrical connectors to the seat track.

   All seats 

9. For a power seat, connect all the seat track motor electrical connectors and attach any retainers holding the wire harness or electrical connectors to the seat track.
10. Connect the safety belt buckle switch electrical connector. Attach any retainers holding the wire harness or electrical connector to the seat track.
11. Attach the seat wire harness main feed in electrical connector(s) to the seat track brackets.
12. Install the front seat backrest. Refer to SEAT BACKREST - FRONT .

    Driver seat with memory 

13. Set the memory seat soft stops. Refer to SETTING THE SOFT STOPS  .