Seat Cushion - Front: Removal
WARNING: This page is about a different car, the 2014 Lincoln MKX and 2014 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The airbag warning indicator illuminates when the correct RCM
fuse is removed and the ignition switch is ON.
NOTE:
The SRS
must be fully operational and free of faults before releasing the vehicle to the customer.
- Remove the front seat. Refer to SEAT - FRONT .
- Release all wire harness and connector retainers to the cushion frame.
- For a seat with a fold-flat backrest, separate the 2 fold-flat recliner cable holders from the bottom of the cushion frame.
- If equipped, disconnect the cushion TED electrical connector.
- If equipped, disconnect the 2 heater mat electrical connectors.
- Separate the pin-type retainers from the cushion frame.
- Remove the 4 seat track-to-cushion frame bolts and cushion assembly.