LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2013 >> Edge SEL, 2.0L Eng VIN 9 >> Repair and Diagnosis >> External Pages >> Different car >> Section 257 (Seat System - Seats) >> Removal And Installation >> Seat Control Switch - Rear Seat >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2014 Lincoln MKX and 2014 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.

Vehicles without power liftgate 

  1. Remove the quarter trim panel. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION .

    Vehicles with power liftgate 

  2. Pull out and remove the power liftgate strut cover in the quarter trim panel.

    All vehicles 

  3. Remove the seat control switch.
    • Disconnect the electrical connector.
    • Squeeze the tab at the top and bottom of the seat control switch and remove from the quarter trim panel.
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals