Removal and Installation
WARNING: This page is about a different car, the 2014 Lincoln MKX and 2014 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Electronic modules are sensitive to static electrical charges. If exposed to these charges, damage may result.
NOTE:
Prior to the replacement of the module, it is necessary to upload the module configuration information to the appropriate scan tool. This information must be downloaded into the new module after installation. For additional information, refer to
MODULE CONFIGURATION
.
-
NOTE: This step is necessary only if the Driver Seat Module (DSM) is being replaced.
Upload the module configuration information from the DSM into the scan tool. For additional information, refer to MODULE CONFIGURATION .
-
NOTE: If the driver seat can be moved to a high enough position, the DSM screws can be easily accessed and removed without removing the driver seat.
If necessary, remove the driver seat. For additional information, refer to SEAT - Front .
- Remove the 2 screws.
- Disconnect the electrical connectors and remove the DSM .
-
NOTE: If installing a new DSM , make sure to download the DSM configuration information from the scan tool into the new DSM . For additional information, refer to MODULE CONFIGURATION .
To install, reverse the removal procedure.
- If installing a new DSM, operate the seat track in all directions through the full range of travel in the following sequence to set the soft stops.