Pinpoint Test D: The Power Seat Is Inoperative - Passenger, With Power Recline

WARNING: This page is about a different car, the 2014 Lincoln MKX and 2014 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: If a seat equipped with a seat mounted side air bag is being serviced, the Supplemental Restraint System (SRS) must be depowered. Refer to SUPPLEMENTAL RESTRAINT SYSTEM .

NOTE: The air bag warning lamp illuminates when the Restraints Control Module (RCM) fuse is removed and the ignition switch is ON. This is normal operation and does not indicate an SRS fault.

NOTE: The SRS must be fully operational and free of faults before releasing the vehicle to the customer.

D1 CHECK THE PASSENGER SEAT CONTROL SWITCH FOR VOLTAGE
- Ignition OFF.
- Depower the SRS . Refer to SUPPLEMENTAL RESTRAINT SYSTEM (SRS) DEPOWERING AND REPOWERING .
- Disconnect: Passenger Seat Side Air Bag C327.
- Disconnect: Passenger Seat Control Switch C3026.
- WARNING: Make sure no one is in the vehicle and there is nothing blocking or placed in front of any airbag when the battery is connected. Failure to follow these instructions may result in serious personal injury in the event of an accidental deployment.
  
  Connect the battery ground cable. Refer to BATTERY, MOUNTING AND CABLES .
- Measure the voltage between passenger seat control switch C3026-5 , circuit SBB42 (YE/RD), harness side and ground.
  
  Fig 1: Measuring Voltage Between Passenger Seat Control Switch (C3026-5), Circuit SBB42 (YE/RD), Harness Side And Ground
  Courtesy of FORD MOTOR CO.
Is the voltage greater than 10 volts?
- Yes : GO to D2 .
- No : VERIFY Battery Junction Box (BJB) fuse 42 (30A) is OK. If OK, REPAIR the circuit. If not OK, REFER to the SYSTEM WIRING DIAGRAMS to identify possible causes of the circuit short. TEST the system for normal operation.
  DISCONNECT the battery ground cable. CONNECT passenger seat side air bag module C327.
  
  REPOWER the SRS . REFER to SUPPLEMENTAL RESTRAINT SYSTEM .
D2 CHECK THE PASSENGER SEAT CONTROL SWITCH GROUND CIRCUIT FOR AN OPEN
- Measure the resistance between passenger seat control switch C3026-3 , circuit GD145 (BK/BU), harness side and ground.
  
  Fig 2: Measuring Resistance Between Passenger Seat Control Switch (C3026-3), Circuit GD145 (BK/BU), Harness Side And Ground
  Courtesy of FORD MOTOR CO.
Is the resistance less than 5 ohms?
- Yes : INSTALL a new passenger seat control switch. REFER to SEAT CONTROL SWITCH - FRONT . TEST the system for normal operation.
  DISCONNECT the battery ground cable. CONNECT passenger seat side air bag module C327.
  
  REPOWER the SRS . REFER to SUPPLEMENTAL RESTRAINT SYSTEM .
- No : REPAIR the circuit. TEST the system for normal operation.
  DISCONNECT the battery ground cable. CONNECT passenger seat side air bag module C327.
  
  REPOWER the SRS . REFER to SUPPLEMENTAL RESTRAINT SYSTEM .