LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2013 >> Edge SEL, 2.0L Eng VIN 9 >> Repair and Diagnosis >> External Pages >> Different car >> Section 256 (Anti-Lock Brake System (Abs) And Stability Control) >> Removal And Installation >> Wheel Speed Sensor - Rear >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2014 Lincoln MKX and 2014 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the wheel and tire. For additional information, refer to WHEELS AND TIRES .
  2. Disconnect the wheel speed sensor electrical connector.
  3. Disconnect the pushpin fasteners.
  4. Remove the wheel speed sensor bolt and the wheel speed sensor.
    • To install, tighten to 9 Nm (80 lb-in).
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals