LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2013 >> Edge SEL, 2.0L Eng VIN 9 >> Repair and Diagnosis >> External Pages >> Different car >> Section 253 (Parking Brake System - Parking Brake & Actuation) >> Removal And Installation >> Parking Brake Cable - Rear, LH >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2014 Lincoln MKX and 2014 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. Relieve the tension in the parking brake cable by loosening the parking brake cable equalizer adjustment nut.
    Fig 1: Locating Parking Brake Cable Equalizer Adjustment Nut
    G06500778Courtesy of FORD MOTOR CO.
  3. Disconnect the LH parking brake cable from the parking brake cable equalizer.
  4. Squeeze the tabs and disconnect the LH parking brake cable from the bracket.
  5. Remove the 3 parking brake cable bracket bolts.
    • To install, tighten to 23 Nm (17 lb-ft).
  6. Remove the stabilizer bar link nut and position the stabilizer bar link aside.
    • To install, tighten to 23 Nm (17 lb-ft).
  7. Release the parking brake cable from the brake caliper lever and remove the parking brake cable.
  8. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals