LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2013 >> Edge SEL, 2.0L Eng VIN 9 >> Repair and Diagnosis >> External Pages >> Different car >> Section 249 (Rear Drive Axle/Differential) >> In-Vehicle Repair >> Stub Shaft Seal >> Removal

Stub Shaft Seal: Removal

WARNING: This page is about a different car, the 2014 Lincoln MKX and 2014 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: This procedure is for vehicles equipped with a stamped steel cover on the Rear Drive Unit (RDU) only. Vehicles with a aluminum cover on the RDU  have no seal installing tools at this time.
NOTE: The RDU  does not have stub shaft pilot bearings. It has stub shaft seals only.
  1. Remove the halfshaft. For additional information, refer to REAR DRIVE HALFSHAFTS .
  2. Using the Torque Converter Fluid Seal Remover and Slide Hammer, remove the stub shaft seal.
    Fig 1: Removing Stub Shaft Seal Using Torque Converter Fluid Seal Remover And Slide Hammer
    G06065011Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals