LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2013 >> Edge SEL, 2.0L Eng VIN 9 >> Repair and Diagnosis >> External Pages >> Different car >> Section 244 (Exterior Lighting System) >> Removal And Installation >> Rear Lamp Assembly >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2014 Lincoln MKX and 2014 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the 2 rear lamp assembly bolts.
  2. NOTE: The rear lamp assembly is held in place by snap-type retainers.

    Pull rear lamp assembly straight rearward to disconnect and remove the rear lamp assembly.

    • Disconnect the rear lamp assembly electrical connector.
  3. To install, reverse the removal procedure.
    • An audible click should be heard when the rear lamp assembly is fully seated to the quarter panel.
scientia non olet · About LEMON Manuals