Removal and Installation
WARNING: This page is about a different car, the 2014 Lincoln MKX and 2014 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
The bulb contains gas under pressure. The bulb may shatter if the glass envelope is scratched or if the bulb is dropped. Handle the bulb only by its base. Avoid touching the glass envelope. Failure to follow these instructions may result in personal injury.
NOTE:
The headlamp bulb should not be removed from the headlamp until just before a new bulb is installed. Removing the bulb for an extended period of time may affect headlamp bulb performance. Contaminants may enter the headlamp where they can settle on the lens and reflector. Never turn on the headlamps with the bulb removed from the headlamp.
NOTE:
Make sure the headlamp switch and the ignition switch are in the OFF position.
- Remove the headlamp bulb access cover.
- Disconnect the headlamp bulb electrical connector.
- Rotate the headlamp bulb approximately one-eighth turn counterclockwise and remove the headlamp bulb.
- To install, reverse the removal procedure.