LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2013 >> Edge SEL, 2.0L Eng VIN 9 >> Repair and Diagnosis >> External Pages >> Different car >> Section 242 (Steering Column Switches) >> Removal And Installation >> Steering Column Control Module (SCCM) >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2014 Lincoln MKX and 2014 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
  1. NOTE: This step is only necessary when installing a new component.
    NOTE: The PMI  process must begin with the current SCCM  installed. If the current SCCM  does not respond to the diagnostic scan tool, the tool may prompt for As-Built Data as part of the repair.

    Using a diagnostic scan tool, begin the PMI  process for the SCCM  following the on-screen instructions.

  2. Remove the steering wheel rotation sensor. For additional information, refer to ANTI-LOCK BRAKE SYSTEM (ABS) AND STABILITY CONTROL .
  3. Disconnect the 3 Steering Column Control Module (SCCM) electrical connectors.
  4. Remove the 2 SCCM  screws and the SCCM  .
    • To install, tighten to 3 Nm (27 lb-in).
  5. To install, reverse the removal procedure.
  6. NOTE: This step is only necessary when installing a new component.

    Using a diagnostic scan tool, complete the PMI  process for the SCCM  following the on-screen instructions.

scientia non olet · About LEMON Manuals