LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2013 >> Edge SEL, 2.0L Eng VIN 9 >> Repair and Diagnosis >> External Pages >> Different car >> Section 242 (Steering Column Switches) >> Removal And Installation >> Start/Stop Switch >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2014 Lincoln MKX and 2014 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.

MKX 

  1. Remove the instrument panel LH upper section. For additional information, refer to INSTRUMENT PANEL AND CONSOLE .

    Edge 

  2. Remove the center console LH upper finish molding.
    Fig 1: Locating Center Console LH Upper Finish Molding
    G09291794Courtesy of FORD MOTOR CO.
  3. Remove the instrument panel right finish panel.
    Fig 2: Locating Instrument Panel Right Finish Panel
    G09291795Courtesy of FORD MOTOR CO.

    Edge and MKX 

  4. Disconnect the start/stop switch electrical connector.
  5. Using a pocket screwdriver (or similar tool), disengage the 4 retainer tabs and remove the start/stop switch.
    Fig 3: Locating Start/Stop Switch Retainer Tabs
    G09291796Courtesy of FORD MOTOR CO.
  6. To install, reverse the removal procedure.