Remote Function Actuator (RFA) Module Programming

WARNING: This page is about a different car, the 2014 Lincoln MKX and 2014 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.

If it is necessary to replace the RFA module, the replacement module must be programmed. Carry out the following scan tool functions if a new RFA module is installed:

NOTE: All of the following scan tool functions must be completed before the vehicle will start.

Programmable Module Installation (PMI) - This process configures the new module with specific vehicle information. Refer to PROGRAMMABLE MODULE INSTALLATION (PMI) .
PATS Parameter Reset - This process initiates an exchange of information between the RFA module and the PCM specific to the anti-theft/engine immobilizer feature. Refer to Passive Anti-Theft System (Pats) Parameter Reset-Intelligent Access (IA) in ANTI-THEFT SYSTEM - PASSIVE ANTI-THEFT SYSTEM (PATS) .
IA Key Programming - This process programs the IA keys to the RFA . Refer to Key Programming Using Diagnostic Equipment-Intelligent Access (IA) in ANTI-THEFT SYSTEM - PASSIVE ANTI-THEFT SYSTEM (PATS) .