LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2013 >> Edge SEL, 2.0L Eng VIN 9 >> Repair and Diagnosis >> External Pages >> Different car >> Section 242 (Steering Column Switches) >> Description And Operation >> Steering Column Switches >> Push Button Start System Ignition Modes >> Notes

Push Button Start System Ignition Modes: Notes

WARNING: This page is about a different car, the 2014 Lincoln MKX and 2014 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.

The push button start system has 4 ignition modes:

The start/stop switch is used in conjunction with the Intelligent Access (IA) key and brake pedal to achieve the different ignition modes as indicated in the table below. For additional information on the IA key, refer to ANTI THEFT - PASSIVE ANTI-THEFT SYSTEM (PATS) .

IGNITION ENTRY CONDITION DESCRIPTION

Ignition Entry Condition Desired Ignition Modes Action
OFF ACC Press the start/stop switch without pressing the brake pedal.
OFF RUN (engine off) Press the start/stop switch twice without pressing the brake pedal.
Any ignition mode START Press and hold the brake pedal and then push the start/stop switch.
RUN (engine off) OFF Press the start/stop switch. On some vehicles, the ignition turns off automatically after 30 minutes.
RUN (vehicle in motion) OFF Press and hold the start/stop switch for approximately 1 second. On some vehicles, press the start/stop switch 3 times within 2 seconds.