LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2013 >> Edge SEL, 2.0L Eng VIN 9 >> Repair and Diagnosis >> External Pages >> Different car >> Section 241 (Information Center - Instrumentation, Message Center, And Warning Chimes) >> Diagnosis And Testing >> Instrumentation, Message Center and Warning Chimes >> Pinpoint Tests >> Pinpoint Test AW: DTC U0154:00 >> Pinpoint Test Aw: DTC U0154:00

Pinpoint Test Aw: DTC U0154:00

WARNING: This page is about a different car, the 2014 Lincoln MKX and 2014 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
  1. AW1 VERIFY THE CUSTOMER CONCERN 
    • Ignition ON.
    • Verify there is an observable symptom present.

      Is an observable symptom present? 

      • Yes  : GO to  AW2.
      • No  : The system is operating normally at this time. The DTC may have been set due to high network traffic or an intermittent fault condition.
  2. AW2 CHECK THE COMMUNICATION NETWORK 
    • Ignition ON.
    • Enter the following diagnostic mode on the scan tool: Network Test.
    • Carry out the network test.

      Does the OCSM pass the network test? 

  3. AW3 RETRIEVE THE RECORDED DTCs FROM THE OCSM SELF-TEST 
    • Check for recorded DTCs from the OCSM self-test.

      Is DTC U3003:16 or DTC U3003:17 recorded? 

  4. AW4 RETRIEVE THE RECORDED DTCs FROM THE IPC SELF-TEST 
    • Check for recorded DTCs from the IPC  self-test.

      Is DTC U3003:16 or DTC U3003:17 recorded? 

  5. AW5 RECHECK THE IPC DTCs 
    • Clear the DTCs.
    • Wait 10 seconds.
    • Repeat the IPC  self-test.

      Is DTC U0154:00 still present? 

      • Yes  : GO to  AW6.
      • No  : The system is operating correctly at this time. The DTC may have been set due to high network traffic or an intermittent fault condition.
  6. AW6 CHECK FOR DTC U0154:00 SET IN OTHER MODULES 
    • Clear all DTCs.
    • Ignition OFF.
    • Ignition ON.
    • Wait 10 seconds.
    • Enter the following diagnostic mode on the scan tool: Self-Test.
    • Retrieve the continuous memory DTCs from all modules.

      Is DTC U0154:00 set in the Restraints Control Module (RCM)? 

scientia non olet · About LEMON Manuals