Pinpoint Test AU: DTC U0140:00

WARNING: This page is about a different car, the 2014 Lincoln MKX and 2014 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.

AU1 VERIFY THE CUSTOMER CONCERN
- Ignition ON.
- Verify there is an observable symptom present.
  Is an observable symptom present?
  - Yes : GO to AU2.
  - No : The system is operating normally at this time. The DTC may have been set due to high network traffic or an intermittent fault condition.
AU2 CHECK THE COMMUNICATION NETWORK
- Ignition ON.
- Enter the following diagnostic mode on the scan tool: Network Test.
- Carry out the network test.
  Does the BCM pass the network test?
  - Yes : GO to AU3.
  - No : REFER to MODULE COMMUNICATIONS NETWORK .
AU3 RETRIEVE THE RECORDED DTCs FROM THE BCM SELF-TEST
- Check for recorded DTCs from the BCM self-test.
  Is DTC U3003:16 or DTC U3003:17 recorded?
  - Yes : Refer to BODY CONTROL MODULE (BCM) DTC CHART .
  - No : GO to AU4.
AU4 RETRIEVE THE RECORDED DTCs FROM THE IPC SELF-TEST
- Check for recorded DTCs from the IPC self-test.
  Is DTC U3003:16 or DTC U3003:17 recorded?
  - Yes : For DTC U3003:16, GO to PINPOINT TEST BC .
    For DTC U3003:17, GO to PINPOINT TEST BD .
  - No : GO to AU5.
AU5 RECHECK THE IPC DTCs
NOTE: If new modules were installed prior to the DTC being set, the module configuration may be incorrectly set during the Programmable Module Installation (PMI) or the PMI may not have been carried out.
- Clear the DTCs.
- Wait 10 seconds.
- Repeat the IPC self-test.
  Is DTC U0140:00 still present?
  - Yes : GO to AU6.
  - No : The system is operating correctly at this time. The DTC may have been set due to high network traffic or an intermittent fault condition.
AU6 CHECK FOR DTC U0140 SET IN OTHER MODULES
- Clear all DTCs.
- Ignition OFF.
- Ignition ON.
- Wait 10 seconds.
- Enter the following diagnostic mode on the scan tool: Self-Test.
- Retrieve the continuous memory DTCs from all modules.
  Is DTC U0140 set in the Driver Seat Module (DSM)?
  - Yes : INSTALL a new BCM . REFER to MULTIFUNCTION ELECTRONIC MODULES . CLEAR the DTCs. REPEAT the self-test.
  - No : INSTALL a new IPC . REFER to INSTRUMENT PANEL CLUSTER (IPC) . TEST the system for normal operation.